Findme-Followme Action Script Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
F M -F
IND E OLLOW
FindMe-FollowMe is a feature supported by AOS that enables calls to be redirected based on who is
calling and the availability of the called party. When the FindMe-FollowMe feature is enabled and
configured, an incoming call rings the called party's extension for the amount of time specified by the
number of rings, and then is redirected based on the configuration of the FindMe-FollowMe feature.
Configuring FindMe-FollowMe revolves around two main actions: configuring the user's contact
group(s), and configuring the scripts used to determine which numbers are dialed in the FindMe-FollowMe
call sequence. Contact groups are the groups of callers the user anticipates permitting to use the
FindMe-FollowMe feature. For more information about configuring contact groups, refer to
FindMe-FollowMe Contact Group Command Set on page
The second part of configuring FindMe-FollowMe is to specify the actions taken when an incoming call is
received. The configurable actions include: calling the user extension, calling an internal extension, calling
an external number, forwarding the call to an auto attendant, forwarding the call to voicemail, or sending
an email to the called party. FindMe-FollowMe actions do not, however, include calling ring groups. Each
of these actions that places a call can be configured for a specific timeout in which to stop the call, as well
as prompt the called party for dual tone multi-frequency (DTMF) digits to manage the call. Each
FindMe-FollowMe contact group can have 1 action script associated with it, and each script can have up to
10 actions, each of which can place up to 4 calls. Actions are numbered in the order you want them to be
performed, but they can be entered in the command line interface (CLI) in any order. If you are working
with actions in parallel, rather than sequence, configuring different ring times for different actions causes
FindMe-FollowMe to delay the next action until the maximum ring time expires for the first action. This
command set outlines the available commands for configuring FindMe-FollowMe action scripts.
For more information about configuring the FindMe-FollowMe feature, refer to the Configuring User
Accounts on the NetVanta 7000 Series quick configuration guide available online at
https://supportforums.adtran.com.
To create a FindMe-FollowMe action script for a voice user, enter the script command at the voice user
configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice user 4444
(config-4444)#script Business
(config-4444-sc-Business)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
60000CRG0-35E
M A S
E CTION CRIPT
Copyright © 2012 ADTRAN, Inc.

FindMe-FollowMe Action Script Command Set

C S
OMMAND ET
3852.
3844