ADTRAN AOS Version R10.1.0 Command Reference Manual page 3019

Command Reference Guide
spt-threshold
Use the spt-threshold command to change the protocol-independent multicast (PIM) sparse shortest path
tree (SPT) threshold, which specifies the number of packets the router sends using the rendezvous point
(RP) before switching to the SPT. Use the no form of this command to return to the default setting.
Variations of this command include:
spt-threshold <value>
spt-threshold infinity
Syntax Description
<value>
infinity
Default Values
By default, the SPT threshold is set to 1 packet.
Command History
Release 11.1
Usage Examples
The following example sets the SPT threshold at five packets:
(config)#router pim-sparse
(config-pim-sparse)#spt-threshold 5
60000CRG0-35E
Optional. Specifies the number of packets the routing switch sends using
the RP before switching to the SPT. Valid range is 1 to
4294967295 packets.
Optional. Causes all sources to use the shared RP tree.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Router (PIM Sparse) Command Set
3019