ADTRAN AOS Version R10.1.0 Command Reference Manual page 3937

Command Reference Guide
set peer <ip address>
Use the set peer command to set the IP address of the peer device. Use the no form of this command to
remove a peer device.
Syntax Description
<ip address>
Default Values
No default values are necessary for this command.
Command History
Release 4.1
Functional Notes
If no peer IP address is configured, the manual crypto map is not valid and not complete. A peer IP
address is required for manual crypto maps. To change the peer IP address, the no set peer command
must be issued first; then the new peer IP address can be configured.
Usage Examples
The following example sets the peer IP address of 10.100.23.64:
(config-crypto-map)#set peer 10.100.23.64
60000CRG0-35E
Specifies the IP address of the peer device. IP addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Crypto Map Manual Command Set
3937