ADTRAN AOS Version R10.1.0 Command Reference Manual page 3106

Command Reference Guide Ethernet OAM CFM Command Set
mep-enabled
Use the mep-enabled command to enable the maintenance endpoint (MEP) and all the MEPs in its
association. Use the no form of this command to halt all associated MEP functionality for this MEP.
Syntax Description
No subcommands.
Default Values
By default, all MEPs are disabled.
Command History
Release 17.4 Command was introduced.
Functional Notes
When an MEP is disabled, no frames are sent or received by the MEP, but all other configuration
properties are retained.
For more information regarding Ethernet operations, administration, and maintenance (OAM) connectivity
fault management (CFM), refer to the Ethernet OAM CFM in AOS configuration guide available online at
https://supportforums.adtran.com (article number 3013).
Usage Examples
The following example enables an MEP:
(config-eth 0/1)#ethernet-cfm mep Domain1 association1 100 down
(config-eth 0/1-mep)#mep-enabled
(config-eth 0/1-mep)#
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 3106