Router (Ospf) Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
R (OSPF) C
OUTER
To activate the Router (Open Shortest Path First (OSPF)) Configuration mode, enter the router ospf
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router ospf
(config-ospf)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
area <area id> default-cost <value> on page 2995
area <area id> range <ip address> <subnet mask> on page 2996
area <area id> stub on page 2997
auto-cost reference-bandwidth <value> on page 2998
default-information-originate on page 2999
default-metric <value> on page 3000
distance <number> on page 3001
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3003
maximum-paths <value> on page 3004
network <ip address> <wildcard mask> area <area id> on page 3005
redistribute bgp on page 3006
redistribute connected on page 3007
redistribute rip on page 3008
redistribute static on page 3010
summary-address <ip address> <subnet mask> on page 3012
timers lsa-group-pacing <value> on page 3013
timers spf <delay> <hold> on page 3014
60000CRG0-35E
S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Router (OSPF) Command Set

2994