ADTRAN AOS Version R10.1.0 Command Reference Manual page 3107

Command Reference Guide
priority <value>
Use the priority command to specify the 802.1p priority given to Ethernet operations, administration, and
maintenance (OAM) connectivity fault management (CFM) frames and linktrace messages transmitted by
the maintenance endpoint (MEP). Use the no form of this command to return the priority to the default
value.
Syntax Description
<value>
Default Values
By default, the priority value is 7.
Command History
Release 17.4
Functional Notes
Priority only applies to CFM frames if the MEP's interface supports virtual local area network (VLAN) tags
and the message will be sent with a tag.
For more information regarding Ethernet OAM CFM, refer to the Ethernet OAM CFM in AOS configuration
guide available online at
Usage Examples
The following example specifies a priority of 3 for CFM frames and linktrace messages transmitted by this
MEP:
(config-eth 0/1)#ethernet-cfm mep Domain1 association1 100 down
(config-eth 0/1-mep)#priority 3
(config-eth 0/1-mep)#
60000CRG0-35E
Specifies the priority. Range is 0 to 7.
Command was introduced.
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
(article number 3013).
3107