Ike Client Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
IKE C C
LIENT OMMAND
To activate the Internet Key Exchange (IKE) Client mode, enter the crypto ike client command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
dns-server on page 3944
ip-range <start ip address> <end ip address> on page 3945
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3946
netbios-name-server <ip address> <secondary> on page 3947
For virtual private network (VPN) configuration example scripts, refer to the VPN
configuration guide located on the AOS Documentation CD provided with your unit.
60000CRG0-35E
S
ET
Copyright © 2012 ADTRAN, Inc.

IKE Client Command Set

3943