ADTRAN AOS Version R10.1.0 Command Reference Manual page 3521

Command Reference Guide Voice ISDN Trunk Command Set
t38 ced auto-generate
Use the t38 ced auto-generate command to specify when the digital signal processor (DSP) should
regenerate the called station identifier (CED) signal toward the time division multiplexed (TDM) endpoint.
If auto-generate is enabled, the DSP generates the CED signal only when it does not receive CED indicator
packets from the Voice over IP (VoIP) endpoint. If auto-generate is disabled, the DSP generates the CED
signal only when it does receive CED indicator packets from the VoIP endpoint. Using the no version of
this command disables CED auto-generate.
Syntax Description
No subcommands.
Default Values
By default, CED auto-generate is disabled.
Command History
Release A5.01 Command was introduced.
Functional Notes
This command is only available on AOS voice products that have Freescale DSP. This includes the Total
Access 900(e) Series, the NetVanta 6310/6330 Series, and the NetVanta 7000 Series products.
This command is used to help in troubleshooting T.38 interoperability issues. This command should only
be issued by advanced users or at the direction of ADTRAN technical support.
Usage Examples
The following example enables CED auto-generate for the T.38 session on the trunk:
(config)#voice trunk t02 type isdn
(config-t02)#t38 ced auto-generate
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 3521