ADTRAN AOS Version R10.1.0 Command Reference Manual page 3861

Command Reference Guide FindMe-FollowMe Contact Group Command Set
ringback
Use the ringback command to enable ringback for the contact group. When ringback is enabled, inbound
FindMe-FollowMe calls are only answered when an outbound call is answered or if one of the
FindMe-FollowMe actions requires the call to be answered (for example, voicemail). If ringback is
disabled, then the call is answered immediately, any configured greetings are played, and music on hold is
eventually played while the called party is located. Using the no form of this command disables ringback.
Syntax Description
No subcommands.
Default Values
By default, ringback is disabled.
Command History
Release A4.01 Command was introduced.
Functional Notes
Ringback must be disabled for any contact group configured prompts or greetings to be played. However,
using the prompts and greetings can drain system resources. ADTRAN recommends you use ringback as
much as possible to save these resources.
Usage Examples
The following example enables ringback for contact group 2 in voice user 4444's FindMe-FollowMe
configuration:
(config)#voice user 4444
(config-4444)#contact-group 2
(config-4444-cg-2)#ringback
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 3861