ADTRAN AOS Version R10.1.0 Command Reference Manual page 2990

Command Reference Guide
test list weighted
Use the test list weighted command to enter the Weighted Track Test List Configuration mode, which is
used to specify multiple objects (schedules, probes, or interfaces) to be tested. Objects listed in a weighted
track test are assigned a specific weight value. The total weight of all the objects in the list is compared to
a user-specified threshold to determine whether the track passes or fails. Use the no form of this command
to remove the test list.
The following additional subcommands are available once you have entered the Weighted Track Test List
Configuration mode:
if interface <interface> ip-routing weight <value>
if interface <interface> line-protocol weight <value>
if probe <name> weight <value>
if schedule <name> weight <value>
if not interface <interface> ip-routing weight <value>
if not interface <interface> line-protocol weight <value>
if not probe <name> weight <value>
if not schedule <name> weight <value>
threshold <number>
threshold pass <number> fail <number>
Syntax Description
if [probe | schedule | interface]
if not [probe | schedule | interface]
<interface>
ip-routing
line-protocol
<name>
weight <value>
threshold <number>
pass <number>
60000CRG0-35E
Specifies a single conditional test to be added to the test track list.
Specifies a single conditional test to be added to the test track list.
The not keyword indicates that the individual track state will
negate the result of the object test.
Specifies the interface to be added to the test track list. Specify an
interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface
id]>. For example, for an Ethernet subinterface, use eth 0/1.1; for
a PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1;
and for a virtual local area network interface, use vlan 1. Type if
interface ? for a complete list of valid interfaces.
Specifies the interface's ability to perform IP routing will be tested.
Specifies the line-protocol state of an interface will be tested.
Specifies the name of the probe or schedule.
Specifies the weight value to use if this test is successful. Range is
1 to 65535.
Specifies a baseline weight for state transitions. Range is 1 to
4294967295.
Optional. Specifies the number which, if reached or exceeded, will
change the state of the track test list to pass. Range is 1 to
4294967295.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Track Command Set
2990