Table of Contents
Advertisement
Command Reference Guide
set default interface
Use the set default interface command to specify a default interface to redirect traffic to the specified
interface if there is no specific routing information for the traffic. If more than one interface is specified,
the router uses the first available interface from the list. Use the no form of this command to remove the
default interface. Variations of this command include:
set default interface <interface>
set default interface null 0
Syntax Description
<interface>
null 0
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Release A4.01
Usage Examples
The following example sets the default interface as ppp 1 interface:
(config)#route-map MYMAP permit 100
(config-route-map)#set default interface ppp 1
60000CRG0-35E
Specifies the default interface. Specify an interface in the format <interface
type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for a T1
interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a PPP
interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1.
Type set default interface ? for a list of valid interface types.
Redirects traffic to the specified interface regardless of available routing
information.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Route Map Command Set
3322
Advertisement
Table of Contents
