Route Map Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
R M C
OUTE AP
The Route Map Command Set contains commands used to match attributes within a route for the purpose
of filtering. This section also contains set commands that are optionally used to apply attributes to the
routes that are being filtered.
To activate the Route Map Configuration mode, enter the route-map command at the Global
Configuration mode prompt. Refer to the command
For example:
>enable
#configure terminal
(config)#route-map MyMap permit 100
(config-route-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3302
match as-path <name> on page 3303
match community <name> on page 3304
match ip address <name> on page 3305
match ip address prefix-list <name> on page 3306
match ip dscp on page 3307
match ip precedence on page 3311
match ipv6 address <ipv6 acl name> on page 3313
match ip address prefix-list <name> on page 3306
match length <minimum> <maximum> on page 3315
match metric <value> on page 3316
match tag <number> on page 3317
set as-path prepend on page 3318
set comm-list <name> delete on page 3319
set community on page 3320
set default interface on page 3322
60000CRG0-35E
S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.
route-map on page 1305

Route Map Command Set

for additional information.
3300