Crypto Map Manual Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
C M M
RYPTO AP
To activate the Crypto Map Manual mode, enter a valid version of the crypto map ipsec-manual
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-manual
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description <text> on page 70
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 3934
match address <name> on page 3935
set peer <ip address> on page 3937
set session-key on page 3938
set transform-set <name> on page 3942
For virtual private network (VPN) configuration example scripts, refer to the VPN
configuration guide located on the AOS Documentation CD provided with your unit.
60000CRG0-35E
C
ANUAL OMMAND
Copyright © 2012 ADTRAN, Inc.

Crypto Map Manual Command Set

S
ET
3933