ADTRAN AOS Version R10.1.0 Command Reference Manual page 3515

Command Reference Guide
rtp packet-delay
Use the rtp packet-delay command to configure the maximum Realtime Transport Protocol (RTP) packet
delays. This command is used to set the allowable limits of latency on the network. Use the no form of this
command to return to the default value. Variations of this command include:
rtp packet-delay fax <value>
rtp packet-delay maximum <value>
rtp packet-delay nominal <value>
Syntax Description
fax <value>
maximum <value>
nominal <value>
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Usage Examples
The following example configures the RTP fax delay time on trunk T01 to 10 milliseconds:
(config)#voice trunk t01 type isdn
(config-t01)#rtp packet-delay fax 10
60000CRG0-35E
Sets the fax delay time in milliseconds. Range is 0 to 500 milliseconds.
Sets the maximum delay time in increments of 10 milliseconds. Range is
40 to 320 milliseconds.
Sets the nominal delay time in increments of 10 milliseconds. Range is
10 to 240 milliseconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice ISDN Trunk Command Set
3515