Table of Contents
Advertisement
Command Reference Guide
host client-identifier
Use the host client-identifier command to create a Dynamic Host Control Protocol version 6 (DHCPv6)
host entry within the DHCPv6 server pool. This command creates a host entry in the server pool, and
enters the DHCPv6 Host Configuration mode. The command also specifies the manual binding of a set of
information to a single client as identified by a DHCPv6 client ID (DUID). Use the no form of this
command to remove the DUID from the server pool. Variations of this command include:
host client-identifier <client DUID>
host client-identifier <client DUID> <IAID>
Syntax Description
<client DUID>
<IAID>
Default Values
By default, no host DUID is specified.
Command History
Release R10.1.0
Functional Notes
The value specified by this command is used to allow a single device, or interface, to match the DHCPv6
server pool and is used as part of the automatic pool selection algorithm that matches DHCPv6 client
requests to the best pool from which to assign information to the client.
Using this command also enters the DHCPv6 Host Configuration mode. From the Host Configuration
mode, you can specify Internet Protocol version 6 (IPv6) address and hostname bindings for a single
DHCPv6 client. For more information about the DHCPv6 Host Configuration mode, refer to
Server Pool Host Command Set on page
Usage Examples
The following example creates a DHCPv6 host DUID of F2A4C9 and enters the DHCPv6 Host
Configuration mode:
(config)#ipv6 dhcp pool MyPool
(config-dhcpv6)#host client-identifier F2A4C9
(config-dhcpv6-host)#
60000CRG0-35E
Specifies the DUID of the client to be matched as a DHCPv6 host. The
DUID is expressed as a hexadecimal value.
Optional. Specifies a hexadecimal value that represents the IAID expected
in the DHCPv6 client request.
Command was introduced.
3087.
Copyright © 2012 ADTRAN, Inc.
DHCPv6 Pool Command Set
DHCPv6
3074
Advertisement
Table of Contents
