ADTRAN AOS Version R10.1.0 Command Reference Manual page 3328

Command Reference Guide
set ip precedence
Use the set ip precedence command to configure the route map to set the precedence value in the IP
header of the packet for traffic serviced by the route map. For more details on IP precedence values, refer
to the command match ip precedence on page
specified IP precedence value. Variations of this command include:
set ip precedence <value>
set ip precedence critical
set ip precedence flash
set ip precedence flash-override
set ip precedence immediate
set ip precedence internet
set ip precedence network
set ip precedence priority
set ip precedence routine
Syntax Description
<value>
routine
priority
immediate
flash
flash-override
critical
internet
network
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Usage Examples
The following example sets an IP precedence value of critical in the IP header of the route map named
MYMAP:
(config)#route-map MYMAP permit 100
(config-route-map)#set ip precedence critical
60000CRG0-35E
3311. Use the no form of this command to remove the
Specifies matching the IP precedence (in numeric value). Valid range is
0 to 7 in ascending order of importance.
Specifies matching the IP precedence routine. (Numeric value of 0.)
Specifies matching the IP precedence priority. (Numeric value of 1.)
Specifies matching the IP precedence immediate. (Numeric value of 2.)
Specifies matching the IP precedence flash. (Numeric value of 3.)
Specifies matching the IP precedence flash-override. (Numeric value of 4.)
Specifies matching the IP precedence critical. (Numeric value of 5.)
Specifies matching the IP precedence internet. (Numeric value of 6.) This
level is reserved for internal network use.
Specifies matching the IP precedence network. (Numeric value of 7.) This
level is reserved for internal network use.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Route Map Command Set
3328