ADTRAN AOS Version R10.1.0 Command Reference Manual page 3708

Command Reference Guide
contact-group <group number>
Use the contact-group command to create a FindMe-FollowMe contact group for the user and enter the
group's configuration mode. Using the no form of this command removes the contact group from the
user's configuration.
Syntax Description
<group number>
Default Values
By default, no contact groups are configured.
Command History
Release A4.01
Functional Notes
FindMe-FollowMe must be enabled on the user account to use configured contact groups.
FindMe-FollowMe is enabled using the command
Each contact group is numbered, and group numbers specify which contact group FindMe-FollowMe
searches first. For example, the calling party number will be matched to the permitted calling party number
list in contact group 1 before contact group 2. If a match is found, the actions for contact group 1 are
performed. Otherwise, the next contact group is searched for matches. Each user account can have up to
5 contact groups.
The contact-group command creates a FindMe-FollowMe contact group and enters the group's
configuration mode. Commands in this configuration mode are detailed in the section
Contact Group Command Set on page
Usage Examples
The following example creates contact group 1 for voice user 4444, and enters the group's configuration
mode:
(config)#voice user 4444
(config-4444)#contact-group 1
(config-4444-cg-1)#
60000CRG0-35E
Specifies the contact group number. Valid range is 1 to 5.
Command was introduced.
findme-followme on page
3852.
Copyright © 2012 ADTRAN, Inc.
Voice User Account Command Set
3724.
FindMe-FollowMe
3708