Table of Contents
Advertisement
Command Reference Guide
To create a T1 RBS trunk account using GS and enter the Trunk Account Configuration mode, enter the
following command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type t1-rbs supervision ground-start role user
(config-t01)#
To create a T1 RBS trunk using LS and enter the Trunk Account Configuration mode, enter the following
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type t1-rbs supervision loop-start role user
(config-t01)#
To create a T1 RBS trunk account using wink and enter the Trunk Account Configuration mode, enter the
following command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type t1-rbs supervision wink role [network | user]
(config-t01)#
To create a T1 RBS trunk using immediate supervision and enter the Trunk Account Configuration mode,
enter the following command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice trunk t01 type t1-rbs supervision immediate role [network | user]
(config-t01)#
Not all T1 Trunk commands apply to all T1 trunk types. Use the ? command to display a
list of valid commands.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
exit on page 73
interface on page 74
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
Voice T1 Trunk Command Set
3604
Advertisement
Table of Contents
