Table of Contents
Advertisement
Command Reference Guide
<destination>
<destination port>
<tcp flags>
Default Values
By default, all AOS IPv6 security features are disabled, and there are no configured IPv6 ACLs.
Command History
Release 18.1
60000CRG0-35E
Specifies the destination used for IPv6 packet matching. Destinations can be
expressed in one of three ways:
1.
Using the keyword any to match any IPv6 address.
2. Using host <ipv6 address> to specify a single host address. IPv6
addresses should be expressed in colon hexadecimal format (X:X:X:X::X).
For example, 2001:DB8:1::1.
3. Using <ipv6 prefix/prefix-length> to specify a destination address to match.
IPv6 prefixes should be expressed in colon hexadecimal format
(X:X::X/<Z>). For example, 2001:DB8:3F::/64. The prefix length (<Z>) is
an integer with a value between 0 and 128.
Optional. Specifies that traffic comparison is conducted on the destination port
for the associated protocol (TCP or UDP).The same keywords and port
numbers/names used for the <source port> field are valid for the <destination
port> field. Refer to previously listed <source port> for more details.
Optional. When used with the TCP protocol, this option defines which flag in the
TCP flag to use for traffic matching. The following keywords are the supported
TCP flags:
ack
Matches the TCP acknowledgement header flag.
fin
Matches the TCP finish header flag.
psh
Matches the TCP push header flag.
rst
Matches the TCP reset header flag.
syn
Matches the TCP synchronize header flag.
urg
Matches the TCP urgent pointer header flag.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
IPv6 Access Control List Command Set
gopher (Port 70)
hostname (Port 101) time (Port 37)
ident (Port 113)
irc (Port 194)
klogin (Port 543)
kshell (Port 544)
login (Port 513)
telnet (Port 23)
uucp (Port 540)
whois (Port 43)
www (Port 80)
3180
Advertisement
Table of Contents
