Table of Contents
Advertisement
Command Reference Guide
component <component> vlan
Use the component vlan command to create a set of virtual local area networks (VLANs) as a fixed group
on a particular component and assign these VLANs to be protected by the maintenance association (MA)
on this component. The command also enters the Component Configuration mode. The no form of this
command removes the component definition from the association. Variations of this command include:
component <component> vlan none
component <component> vlan <vlan id>
Syntax Description
<component>
vlan none
vlan <vlan id>
Default Values
By default, no component is defined.
Command History
Release 17.4
Release A5.01
Functional Notes
At least one component must be added to each MA. The components and VLANs are associated so that
the VLANs are protected by the MA to which the component belongs. The first VLAN ID listed is the
primary VLAN ID for the entry being created.
A component must be configured on a VLAN before you can configure its associated
maintenance endpoint (MEP).
For more information regarding Ethernet operations, administration, and maintenance (OAM) connectivity
fault management (CFM) and its operation on AOS products, refer to the Ethernet OAM CFM in AOS
configuration guide available online at
60000CRG0-35E
Specifies the component to be added to the MA. Components are specified
in the form <component type [slot/port]>. For example, for an Ethernet
component, use eth 0/1. To discover available components, enter
component ? at the prompt.
Specifies that this MA component is not attached to a virtual local area
network (VLAN).
Specifies to which VLAN this MA component is attached. VLAN IDs range
from 1 to 4094.
Command was introduced.
Command was expanded to include the Gigabit Ethernet component.
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
(article number 3013).
3096
Advertisement
Table of Contents
