ADTRAN AOS Version R10.1.0 Command Reference Manual page 2958

Command Reference Guide
source-address <ip address>
Use the source-address command to associate an IP address source for probe traffic. Use the no form of
this command to remove the source IP address.
Syntax Description
<ip address>
Default Values
By default, the IP address of the outbound interface is used.
Command History
Release 13.1
Functional Notes
A valid local IP address must be entered for proper functionality.
Usage Examples
The following example configures the source IP address on probe1:
(config)#probe probe1 icmp-echo
(config-probe-probe1)#source-address 10.10.10.1
60000CRG0-35E
Specifies a valid IP address. IP addresses should be expressed in dotted
decimal notation (for example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Command Set
2958