Table of Contents
Advertisement
Command Reference Guide
match
Use the match command to configure the proxy user template match settings for specific traffic patterns.
Use the no form of this command to disable a match setting. Variations of this command include:
match inbound
match outbound
match outbound source contact
match outbound source from
match outbound source from enable-alternate-identity
Syntax Description
inbound
outbound
source
contact
from
enable-alternate-identity
Default Values
By default, the Contact header is used when matching the proxy user template agains outbound traffic.
Command History
Release A5.01
Functional Notes
For more information on the operation and configuration of SIP proxy, refer to the configuration guide
Configuring SIP Proxy in AOS (article number 2183) available online at https://supportforums.adtran.com.
Usage Examples
The following example specifies that the Set1 proxy user template should be used to match against
outbound traffic and that the From header should be used:
(config)#ip sip proxy user-template Set1
(config-template-Set1)#match outbound source from
60000CRG0-35E
Specifies that this proxy user template should be used to match against
inbound traffic.
Specifies that this proxy user template should be used to match against
outbound traffic.
Specifies the Session Initiation Protocol (SIP) header type(s) to use when
matching the proxy user template against outbound traffic.
Specifies that the Contact header should be used when matching the
proxy user template against outbound traffic.
Specifies that the From header should be used when matching the proxy
user template against outbound traffic.
Specifies that the P-Preferred-Indentity, P-Asserted-Identity or
Remote-Party-ID header, if present, should be used in place of the From
header when matching the proxy user template against outbound traffic.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Proxy User Template Command Set
3870
Advertisement
Table of Contents
