ADTRAN AOS Version R10.1.0 Command Reference Manual page 3274

Command Reference Guide
match
Use the match command to specify which traffic should be processed by this quality of service (QoS) map
entry. Use the no form of this command to discontinue matching. Variations of this command include:
match any
match fr-dlci <number>
match ip list <ipv4 acl name>
match ipv6 list <ipv6 acl name>
match ip rtp <port>
match ip rtp <begin port> <end port range>
match ip rtp <begin port> <end port range> all
match ipv6 rtp <port>
match ipv6 rtp <begin port> <end port range>
match protocol bridge
match protocol bridge netbeui
match protocol ip
match protocol ipv6
match vlan <id>
Syntax Description
any
fr-dlci <number>
ip list <ipv4 acl name>
ipv6 list <ipv6 acl name>
ip rtp <port>
ip rtp <begin port> <end port range>
60000CRG0-35E
Match all packets within a QoS map entry that were not
matched in previous map entries. Since map entries are
processed in the order of their sequence numbers, the
match any command can be used to process all packets
(both Internet Protocol version 4 (IPv4) and Internet Protocol
version 6 (IPv6) traffic) not previously matched by a map
entry if it is specified as the last QoS map entry.
Match all packets by the specified Frame Relay data link
connection identifier (DLCI). Indicate the valid DLCI number
from 16 to 1007.
Specifies the name of the IPv4 access control list (ACL) you
want to use to match packets for this QoS map. Refer to
access-list extended <ipv4 acl name> on page 982
information on creating IPv4 ACLs.
Specifies the name of the IPv6 ACL you want to use to match
packets for this QoS map. Refer to
<ipv6 acl name> on page 1181
creating IPv6 ACLs.
Matches IPv4 Realtime Transport Protocol (RTP) packets
with the specified User Datagram Protocol (UDP) destination
port.
Matches IPv4 RTP packets with even UDP destination port
numbers in the specified range.
Copyright © 2012 ADTRAN, Inc.
Quality of Service Map Command Set
ipv6 access-list extended
for more information on
ip
for more
3274