Table of Contents
Advertisement
Command Reference Guide
set transform-set <name>
Use the set transform-set command to assign a transform set to a crypto map. Use the no form of this
command to remove assigned transform sets. Refer to
on page 927
for information on defining transform sets.
Syntax Description
<name>
Default Values
By default, no transform set is assigned to the crypto map.
Command History
Release 4.1
Functional Notes
Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto
map is associated with transform sets that contain specific security algorithms (refer to
transform-set <name> <parameters> on page
If no transform set is configured for a crypto map, then the entry is incomplete and will have no effect on
the system. For manual key crypto maps, only one transform set can be specified.
Usage Examples
The following example first creates a transform set (Set1) consisting of two security algorithms (up to three
may be defined), and then assigns the transform set to a crypto map (Map1):
(config)#crypto ipsec transform-set Set1 esp-3des esp-sha-hmac
(cfg-crypto-trans)#exit
(config)#crypto map Map1 1 ipsec-manual
(config-crypto-map)#set transform-set Set1
60000CRG0-35E
Assigns a transform set to this crypto map by entering the set name.
Command was introduced.
927).
Copyright © 2012 ADTRAN, Inc.
Crypto Map Manual Command Set
crypto ipsec transform-set <name> <parameters>
crypto ipsec
3942
Advertisement
Table of Contents
