ADTRAN AOS Version R10.1.0 Command Reference Manual page 3425

Command Reference Guide
type
Use the type command to configure the group type for the ring group. Variations of this command include:
type all
type executive
type linear
type ucd
Syntax Description
all
executive
linear
ucd
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Usage Examples
The following example configures the ring group 1234 to ring all phones in the ring group each time a call
comes in:
(config)#voice ring-group 1234
(config-1234)#type all
60000CRG0-35E
Configures the group as an all-inclusive ring group. When a ring group call
comes in, all phones ring simultaneously.
Configures an executive ring group. Refer to
<number> on page 3416
Configures the group as a linear hunt ring group. Member phones ring one
at a time until the call is picked up. When the next call comes in, the call
cycle begins again by ringing the first ring group member. Refer to
<number> on page 3421
Configures the group as a uniform call distribution (UCD) ring group.
Member phones ring one at a time until the call is picked up. When the next
call comes in, the system remembers which member extension it last dialed
and then continues the call cycle by ringing the next member in the ring
group.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Ring Group Command Set
executive-extension
for more information.
for more information.
member
3425