ADTRAN AOS Version R10.1.0 Command Reference Manual page 2992

Command Reference Guide
The show track LB-test command is executed to see whether track LB-test is in a PASS state:
#show track LB-test
Current State: PASS
Testing:
+10 if probe LB (PASS)
+20 if probe LB2 (PASS)
+30 if probe LB3 (PASS)
Total = 60 currently, < 25 changes state to FAIL
Dampening Interval: 1 seconds
Time in current state: 2 days, 5 hours, 21 minutes, 13 seconds
Track State Changes: 0
Tracking:
Currently, all probe test commands are in the PASS state. Therefore, the sum of the assigned weights
equals 60. The value of 60 exceeds the specified pass threshold of 35. As a result, the current state of the
track is PASS.
Probe LB and probe LB3 have been forced to fail for demonstration purposes in this example. Output from
the show track LB-test command shows track LB-test to be in a FAIL state.
(config-loop 1)#do show track LB-test
Current State: FAIL (Admin: UP)
Testing:
+10 if probe LB (FAIL)
+20 if probe LB2 (PASS)
+30 if probe LB3 (FAIL)
Total = 20 currently, >= 35 changes state to PASS
Dampening Interval: 1 seconds
Time in current state: 0 days, 0 hours, 0 minutes, 33 seconds
Track State Changes: 1
Tracking:
Only probe LB2 is in the PASS state. Therefore, the sum of the assigned weights equals 20. The value of
20 falls below the FAIL threshold of 25. As a result, the current state of the track is now FAIL.
60000CRG0-35E
(Admin: UP)
Copyright © 2012 ADTRAN, Inc.
Network Monitor Track Command Set
2992