ADTRAN AOS Version R10.1.0 Command Reference Manual page 3122

Command Reference Guide
Changing hardware ACL or hardware access map configuration or application causes
new information to be reinstalled on the hardware. It is possible to run out of hardware
resources depending on how many resources are needed to apply the desired change. If
there are not enough hardware resources to install the new criteria in the hardware, an
error message is displayed. You can view the amount of hardware resources available
using the command
Usage Examples
In the following example, the access map Map1 is configured to operate on both an IP hardware ACL
(Trusted) and a MAC hardware ACL (Untrusted), specifying that both must agree that a frame should be
forwarded before the access list will forward it.
(config)#hw-access-map Map1
(config-hw-access-map)#forward ip Trusted and mac Untrusted
60000CRG0-35E
show hw-filter-resource on page
Copyright © 2012 ADTRAN, Inc.
Hardware ACLs and Hardware Access Maps
518.
3122