Dhcpv6 Pool Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
DHCP 6 P
V OOL
The Dynamic Host Configuration Protocol version 6 (DHCPv6) server pool is created using the ipv6 dhcp
pool command from the Global Configuration mode prompt. This command creates the DHCPv6 server
pool and enters the pool's configuration mode. The server pool is used to define the information to be
assigned to clients by the DHCPv6 server. The pool chosen to serve a specific client's request is
determined by the current pool selection algorithm, just as in DHCPv4. To create a DHCPv6 server pool,
and enter the pool's configuration mode, enter the command as follows:
>enable
#configure terminal
(config)#ipv6 dhcp pool MyPool
(config-dhcpv6)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
All other commands for this command set are described in this section in alphabetical order.
address prefix on page 3068
bootfile <url> on page 3070
client-identifier on page 3071
client-identifier on page 3071
domain-name <name> on page 3073
host client-identifier on page 3074
import on page 3075
information refresh on page 3076
link-address <ipv6 prefix/prefix-length> on page 3077
ntp address <ipv6 address> on page 3078
ntp domain-name <name> on page 3079
option on page 3080
sip address <ipv6 address> on page 3081
sip domain-name <name> on page 3082
sntp-server <ipv6 address> on page 3083
timezone on page 3084
vendor-specific <number> on page 3085
vrf <name> on page 3086
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

DHCPv6 Pool Command Set

3067