ADTRAN AOS Version R10.1.0 Command Reference Manual page 3048

Command Reference Guide
client-name <name>
Use the client-name command to specify the name of a Dynamic Host Configuration Protocol version 4
(DHCPv4) client. Use the no form of this command to remove the configured client name.
Syntax Description
<name>
The specified client name should not contain the domain name.
Default Values
By default, there are no specified client names.
Command History
Release 2.1
Usage Examples
The following example specifies a client name of myclient:
(config)#ip dhcp pool MyPool
(config-dhcp)#client-name myclient
60000CRG0-35E
Identifies the DHCPv4 client (example is client1) using an alphanumeric
string (up to 32 characters in length).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3048