Table of Contents
Advertisement
Command Reference Guide
sip address <ipv6 address>
Use the sip address command to specify the Internet Protocol version 6 (IPv6) address of a Session
Initiation Protocol (SIP) server that is supplied to requesting Dynamic Host Control Protocol version 6
(DHCPv6) clients served by this pool. Use the no form of this command to remove the SIP server address
from the pool. If no SIP server address is specified when using the no form of this command, then all SIP
server addresses are removed from the pool.
Syntax Description
<ipv6 address>
Default Values
By default, no SIP server is specified or sent to the requesting DHCPv6 client.
Command History
Release 18.3
Functional Notes
Multiple server addresses can be entered using multiple instances of this command. Each address is
added or deleted individually. Up to 50 addresses can be entered. These addresses are assigned in the
order they are entered. If the no version of this command is entered without specifying an address, all SIP
server addresses are removed from the pool.
Usage Examples
The following example adds a SIP server address to the DHCPv6 pool:
(config)#ipv6 dhcp pool MyPool
(config-dhcpv6)#sip address 2001:DB8:1::1
60000CRG0-35E
Specifies the SIP server address. IPv6 addresses should be expressed in
colon hexadecimal format (X:X:X:X::X). For example, 2001:DB8:1::1.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv6 Pool Command Set
3081
Advertisement
Table of Contents
