Table of Contents
Advertisement
Command Reference Guide
<screening type>
<privacy setting>
Default Values
By default, SIP diversions are specified as unconditional (unconditional), do not use network screening
(no), and do not use privacy (off).
This command can get very lengthy. To shorten the length of the command, you must elect
to use all default values for the diversion options, or you must override all options.
Command History
Release A4.05
Functional Notes
Both match source and match target templates are defined in the same way as dial plan entries.
Wildcards available for use are as follows:
0-9 = Match exact digit only.
M = Any digit 1 to 8.
X = Any single digit (0 to 9).
N = Any digit 2 to 9.
[123] = Any digit contained in the bracketed list.
Do not use exclamation points, commas, spaces, etc., inside the brackets. Commas are
implied between numbers in the brackets.
The special characters ( ), -, and + are always ignored in the template.
60000CRG0-35E
Optional. Specifies whether the diversion is screened by the network.
Screening types include:
no
Specifies that the diversion used is not screened by the
network.
yes
Specifies that the diversion used is screened by the
network.
Optional. Specifies whether privacy is used when SIP Diversion headers
are added to the SIP messages. Privacy settings include:
full
Specifies that the diversion uses full privacy.
off
Specifies that the diversion does not use privacy.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice SIP Trunk Command Set
3565
Advertisement
Table of Contents
