ADTRAN AOS Version R10.1.0 Command Reference Manual page 3474

Command Reference Guide
rtp dtmf-relay
Use the rtp dtmf-relay command to configure the method by which Realtime Transport Protocol (RTP)
dual tone multi-frequency (DTMF) events are relayed. The dial digits can be sent inband or out-of-band
(OOB) of the voice stream. Use the no form of this command to return to the default value. Variations of
this command include:
rtp dtmf-relay inband
rtp dtmf-relay nte <value>
Syntax Description
inband
nte <value>
Default Values
By default, the rtp dtmf-relay is set for NTE 101.
Command History
Release 9.3
Usage Examples
The following example configures RTP DTMF relay events for inband:
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#rtp dtmf-relay inband
60000CRG0-35E
Specifies that RTP DTMF events be relayed inband in the RTP stream.
Specifies that RTP DTMF events be relayed OOB using named telephone
event (NTE). Enter an NTE value between 96 and 127.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Analog Trunk Command Set
3474