Command Reference Guide
netbios-node-type
Use the netbios-node-type command to specify the type of network basic input/output system (NetBIOS)
node used with Dynamic Host Configuration Protocol version 4 (DHCPv4) clients. Use the no form of this
command to remove a configured NetBIOS node type. Variations of this command include:
netbios-node-type <value>
netbios-node-type b-node
netbios-node-type h-node
netbios-node-type m-node
netbios-node-type p-node
Syntax Description
<value>
b-node
h-node
m-node
p-node
Default Values
By default, the netbios-node-type is set to h-node (hybrid node, numeric value 8).
Command History
Release 2.1
Usage Examples
The following example specifies a client's NetBIOS node type as h-node:
(config)#ip dhcp pool MyPool
(config-dhcp)#netbios-node-type h-node
Alternately, the following also specifies the client's NetBIOS node type as h-node:
(config-dhcp)#netbios-node-type 8
60000CRG0-35E
Specifies the NetBIOS node type using the numerical value. Refer to the
node types below for the corresponding numerical values.
Specifies the broadcast node. Numeric value is 1.
Specifies the hybrid node (recommended). Numeric value is 8.
Specifies the mixed node. Numeric value is 4.
Specifies the peer-to-peer node. Numeric value is 2.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3058