Crypto Map Ike Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
C M IKE C
RYPTO AP
To activate the Crypto Map Internet Key Exchange (IKE) mode, enter a valid version of the crypto map
ipsec-ike command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map MyMap 100 ipsec-ike
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 3917
commit-bit on page 3918
ike-policy <number> on page 3920
(config-crypto-map)#ike-policy 100 on page 3920
match address <name> on page 3921
match track <name> on page 3923
reverse-route on page 3925
set peer on page 3927
set pfs on page 3929
set security-association idle-time <value> on page 3930
set security-association lifetime on page 3931
set transform-set on page 3932
For virtual private network (VPN) configuration example scripts, refer to the Virtual
Private Network configuration guide available on the AOS Documentation CD provided
with your unit, or online at
60000CRG0-35E
S
OMMAND ET
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.

Crypto Map IKE Command Set

(article number 1616).
3916