ADTRAN AOS Version R10.1.0 Command Reference Manual page 3024

Command Reference Guide
distribute-list <name>
Use the distribute-list command to add route filtering functionality by assigning inbound and outbound
access control lists (ACLs) on either a per-interface or global basis. Only one inbound/outbound pair of
ACLs can be configured for a particular interface. Use the no form of this command to disable the filtering.
Variations of this command include:
distribute-list <name> in
distribute-list <name> in <interface>
distribute-list <name> out
distribute-list <name> out <info source>
Syntax Description
<name>
in
in <interface>
out
out <info source>
Default Values
By default, distribute-list filtering is disabled.
Command History
Release 12.1
Release A4.01
Release A5.01
60000CRG0-35E
Specifies an ACL name. This is a standard IP ACL against which the
contents of the incoming/outgoing routing updates are matched.
Applies route filtering to inbound data.
Optional. Specifies the interface in which to apply the ACL. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
distribute-list list1 in ? for a complete list of applicable interfaces.
Applies route filtering to outbound data.
Optional. Specifies the source of the routing information. The source can be
an interface or a routing process (connected, ospf, rip, or static). Type
distribute list <name> out ? for a list of available options.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Command was epxanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Router (RIP) Command Set
3024