Certificate Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
C C
ERTIFICATE
To activate the Certificate Configuration mode, enter the crypto ca certificate chain command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto ca certificate chain MyProfile
(config-cert-chain)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
certificate <serial number> on page 3912
certificate ca <serial number> on page 3913
crl on page 3914
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3915
60000CRG0-35E
S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Certificate Command Set

3911