ADTRAN AOS Version R10.1.0 Command Reference Manual page 3243

Command Reference Guide
rtp dtmf-relay
Use the rtp dtmf-relay command to configure the method by which Realtime Transport Protocol (RTP)
dual tone multi-frequency (DTMF) events are relayed. The dial digits can be sent inband or out-of-band
(OOB) of the voice stream. Use the no form of this command to return to the default value. Variations of
this command include:
rtp dtmf-relay inband
rtp dtmf-relay nte <value>
Syntax Description
inband
nte <value>
Default Values
By default, the rtp dtmf-relay is set for NTE 101.
Command History
Release 9.3
Release 15.1
Release A2
Usage Examples
The following example configures RTP DTMF relay events for inband:
(config)#voice mgcp-endpoint 1
(config-mgcp-1)#rtp dtmf-relay inband
60000CRG0-35E
Specifies that RTP DTMF events be relayed inband in the RTP stream.
Specifies that RTP DTMF events be relayed OOB using named telephone
events (NTEs). Enter an NTE value between 96 and 127.
Command was introduced.
Command was added to the Voice Line Interface.
Command was added to the Media Gateway Control Protocol (MGCP)
endpoint configuration.
Copyright © 2012 ADTRAN, Inc.
MGCP Command Set
3243