Table of Contents
Advertisement
Command Reference Guide
DHCPv4 Pool Command Set
nap
Use the nap command to enable network access protection (NAP) advertisements for the Dynamic Host
Configuration Protocol version 4 (DHCPv4) server pools of AOS units that are operating as DHCPv4
servers. Use the no form of this command to disable NAP advertisements on the server pool.
Syntax Descriptions
No subcommands.
Default Values
By default, NAP advertisements are disabled on DHCPv4 server pools.
Command History
Release 17.8
Command was introduced.
Functional Notes
This command is used if your AOS unit is functioning as a DHCPv4 server and you want DHCPv4 server
pools to advertise that they are NAP compatible because you are using desktop auditing. Desktop auditing
is an AOS feature that collects NAP information through NAP messages sent in DHCPv4 messages
between clients connected to the network and the network server.
Desktop auditing is configured by enabling the feature (using the command
desktop-auditing dhcp on page
932) and by configuring filters to limit the output of the collected NAP information. Information is limited by
specifying local desktop auditing policies. The configuration of these policies is outlined in
Desktop
Auditing Local Policy Command Set on page
3037. For more information about desktop auditing, refer to
the Configuring Desktop Auditing in AOS configuration guide available online at
https://supportforums.adtran.com.
Usage Examples
The following example enables NAP advertisements on the DHCPv4 server pool MyPool:
(config)#ip dhcp pool MyPool
(config-dhcp)#nap
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
3056
Advertisement
Table of Contents
