ADTRAN AOS Version R10.1.0 Command Reference Manual page 3329

Command Reference Guide
set ipv6 next-hop <ipv6 address>
Use the set ipv6 next-hop command to set the next-hop Internet Protocol version 6 (IPv6) address to the
specified address for all routes serviced by the route map. Use the no form of this command to remove the
configured next-hop address.
Syntax Description
<ipv6 address>
Default Values
No default values are necessary for this command.
Command History
Release R10.1.0
Usage Examples
The following example sets the IPv6 address of the next hop to 2001:DB8:1::1 in the header of the route
map named MYMAP:
(config)#route-map MYMAP permit 100
(config-route-map)#set ipv6 next-hop 2001:DB8:1::1
60000CRG0-35E
Specifies a valid IPv6 address. IPv6 addresses should be expressed in
colon hexadecimal notation (X:X:X:X::X), for example, 2001:DB8:1::1.
More than one address can be entered, and the router uses the first
available route from the list.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Route Map Command Set
3329