Table of Contents
Advertisement
Command Reference Guide
ipv6 policy-class <ipv6 acp name> max-sessions <number>
Use the ipv6 policy-class max-sessions command to specify the maximum number of allowed Internet
Protocol version 6 (IPv6) policy sessions on a specific IPv6 access control policy (ACP). For more details
on IPv6 ACP functionality in AOS, refer to the
Use the no form of this command to return to the default value.
Syntax Description
<ipv6 acp name>
<number>
Default Values
By default, the maximum IPv6 ACP sessions allowed are based on the amount of RAM in the AOS unit.
The following table outlines the default values based on RAM:
Command History
Release 18.1
Functional Notes
To set the system-wide maximum limit for ACP sessions (both IPv4 and IPv6), use the command
policy-class max-sessions <number> on page
Usage Examples
The following example allows no more than 100 policy sessions on the IPv6 ACP named PRIVATEv6:
(config)#router rip
(config-rip)#ipv6 policy-class PRIVATEv6 max-sessions 100
60000CRG0-35E
IPv6 Access Control Policy Command Set on page
Identifies the configured IPv6 ACP to which the max-session limit is applied.
Use an alphanumeric descriptor (maximum of 50 characters). All ACP
descriptors are case sensitive.
Specifies the maximum number of allowed IPv6 policy sessions. Valid range
is 1 up to a value based on the amount of RAM in the AOS unit (refer to
Default Values below).
RAM Amount
64 MB
128 MB
256 MB
512 MB
768 MB
1 GB
Command was introduced.
1282.
Copyright © 2012 ADTRAN, Inc.
Router (RIP) Command Set
Default Max Sessions
10000
30000
80000
200000
300000
450000
3192.
3026
Advertisement
Table of Contents
