ADTRAN AOS Version R10.1.0 Command Reference Manual page 3875

Command Reference Guide
target <host>
Use the target command to specify the proxy user's location. This command indicates the host name or IP
address, protocol, and port number to use in locating the proxy user. Use the no form of this command to
remove the target configuration. Variations of this command include:
target <host>
target <host> tcp
target <host> tcp <port>
target <host> udp
target <host> udp <port>
Syntax Description
<host>
tcp
udp
<port>
Default Values
By default, no target server is configured. If a target is configured with no protocol or port specified, the
proxy server operates using UDP on port 5060. If a protocol is specified, but no port is specified, the proxy
server uses port 5060.
Command History
Release A4.01
Usage Examples
The following example specifies the users matching the proxy user template Set1 are located at IP
address 10.10.10.3 and to use UDP port 5061:
(config)#ip sip proxy user-template Set1
(config-template-Set1)#target 10.10.10.3 udp 5061
60000CRG0-35E
Specifies the fully qualified domain name (FQDN) or IP address of the
target server. IP addresses should be expressed in dotted decimal notation
(for example, 208.61.209.1).
Optional. Specifies using Transmission Control Protocol (TCP).
Optional. Specifies using User Datagram Protocol (UDP).
Optional. Specifies the TCP or UDP port used by the target host. Range is 1
to 65535.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Proxy User Template Command Set
3875