Table of Contents
Advertisement
Command Reference Guide
busy-out monitor track <name>
Use the busy-out monitor track command to automatically take a voice trunk out of service based on one
or more conditions. The primary application of this feature is to signal to an attached private branch
exchange (PBX) that because calls routed to the integrated access device (IAD) could fail due to loss of
Session Initiation Protocoal (SIP) trunk connectivity, it should attempt to route the call via another
interface. For more information on creating tracks, refer to
Monitor Track Command Set on page
busy-out monitoring.
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release A4.01
Usage Examples
The following example shuts down trunk T01 when the on_fail track fails:
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#busy-out monitor track on_fail
60000CRG0-35E
2977. Use the no form of this command to remove a track from
Specifies the name of the track to monitor.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Analog Trunk Command Set
track <name> on page 1372
and the
Network
3451
Advertisement
Table of Contents
