ADTRAN AOS Version R10.1.0 Command Reference Manual page 3945

Command Reference Guide
ip-range <start ip address> <end ip address>
Use the ip-range command to specify the range of addresses from which the router draws when assigning
an IP address to a client. Use the no form of this command to remove defined IP ranges.
Syntax Description
<start ip address>
<end ip address>
Default Values
By default, no IP address range is defined.
Command History
Release 4.1
Usage Examples
The following example defines an IP address range for this configuration pool:
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#ip-range 172.1.1.1 172.1.1.25
60000CRG0-35E
Specifies the first IP address in the range for this pool.
Specifies the last IP address in the range for this pool.
IP addresses should be expressed in dotted decimal notation (for example,
10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
IKE Client Command Set
3945