ADTRAN AOS Version R10.1.0 Command Reference Manual page 3094

Command Reference Guide
remote-mep hold-time <minutes>
Use the remote-mep hold-time command to specify the length of time an associated maintenance
endpoint (MEP) remains in the maintenance domain's (MD's) remote MEP database after the MEP has
entered a failed state. Use the no form of this command to return to the default value.
Syntax Description
<minutes>
Default Values
By default, MEPs remain in the MD's MEP database for 100 minutes.
Command History
Release 17.4
Functional Notes
Each MEP that is created is associated with a particular MD. The MDs maintain an MEP database of
remote MEPs, listing all configured and associated remote MEPs within the system. When a remote MEP
fails, it can be removed from this database after a specified amount of time. When the remote MEP entry is
purged, any errors logged relating to the remote MEP are also purged.
For more information regarding Ethernet operations, administration, and maintenance (OAM) connectivity
fault management (CFM) and its operation on AOS products, refer to the Ethernet OAM CFM in AOS
configuration guide available online at
Usage Examples
The following example specifies that remote MEP entries are purged from the MD's remote MEP database
after 60 minutes:
(config)#ethernet cfm domain domain1 level 6
(config-ecfm-domain)#remote-mep hold-time 60
(config-ecfm-domain)#
60000CRG0-35E
Specifies the length of time the associated MEP remains in the MD's MEP
database after the MEP has failed. Range is 1 to 65535 minutes.
Command was introduced.
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
(article number 3013).
3094