Mail Agent Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
M A C
AIL GENT
The mail agent feature of ADTRAN Operating System (AOS) provides a method of adding email
notification to any AOS feature. The mail agent is configured through the command line interface (CLI)
and operates with any AOS feature that has configuration or show commands. The mail agent captures
output from specified commands and emails them to a specified address in the body of an email message.
Email messages are created when a specified event occurs, and are mailed on a specified schedule.
Multiple mail agents can be configured and used at one time. For more information about the creation of
mail agents and their capabilities, refer to the Generic Mail Agent quick configuration guide available
online at https://supportforums.adtran.com
To activate the Mail Agent Configuration mode, enter the mail-client command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#mail-client myagent
(config-mail-client-myagent)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
address on page 3202
body size <bytes> on page 3203
capture commands on page 3204
capture header on page 3205
capture trigger on page 3206
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 3208
send test on page 3209
send trigger on page 3210
server <dns-name/ip address> on page 3211
subject <text> on page 3212
60000CRG0-35E
S
OMMAND ET
(article number 2341).
Copyright © 2012 ADTRAN, Inc.

Mail Agent Command Set

3201