Command Reference Guide
V
C
OICE
OVERAGE
The Voice Coverage Command Set covers the commands used to configure the global call coverage list
used on the AOS product. The call coverage list is used to control call routing when a voice user's phone is
not answered. Call coverage can also be set on a per-user basis using the command
from the user account configuration mode.
To create a global call coverage list and enter the list's configuration mode, enter the voice coverage
command from the Global Configuration mode prompt as follows:
>enable
#configure terminal
(config)#voice coverage Evening
Configuring New Global Call Handling List "Evening".
(config-gch)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 71
exit on page 73
All other commands for this command set are described in this section in alphabetical order.
coverage on page 3800
default on page 3802
60000CRG0-35E
C
S
OMMAND
ET
Copyright © 2012 ADTRAN, Inc.
Voice Coverage Command Set
coverage on page 3711
3799