ADTRAN AOS Version R10.1.0 Command Reference Manual page 2964

Command Reference Guide
Command History
Release 14.1
Release 15.1
Release 17.2
Functional Notes
This command has been modified from its original form. All tolerance configurations before Revision 15.1
are deprecated, but will be supported for existing units that are upgraded.
Usage Examples
The following example configures probe1 to allow 10 consecutive failures before changing the probe
status to FAIL, and requires 5 consecutive passes to change its status to PASS when in the FAIL state:
(config)#probe probe1 icmp-echo
(config-probe-probe1)#tolerance consecutive fail 10 pass 5
In the following example, the probe is configured for rate tolerance. To move to the FAIL state, 5 of the last
10 tests must fail. Once in this state, 8 of the last 10 tests must pass in order to transition the probe back to
PASS:
(config)#probe probe1 icmp-echo
(config-probe-probe1)#tolerance rate fail 5 pass 8 of 10
60000CRG0-35E
Command was introduced.
Command revised to include pass and fail values.
Command was added to the Two-Way Active Measurement Protocol
(TWAMP) and Internet Control Message Protocol (ICMP) timestamp
probes.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Command Set
2964