Network Monitor Track Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
N M
ETWORK ONITOR
This section explains the commands available for Network Monitoring Tracks. Tracks are objects created
to monitor network probes for a change in their state. The tracks can be configured to perform a specific
action based upon the probe state detected. Association between a track and a probe occurs through
referencing the probe in the track's configuration. Once the track is registered with the probe, whenever a
change occurs with the probe's state, an event is sent to the track.
Additional configuration commands are available for creating probes. These are explained in the
Monitor Probe Command Set on page
To activate the Network Monitor Track Configuration mode, enter the track command at the Global
Configuration mode prompt followed by the name of the track. For example:
>enable
#configure terminal
(config)#track track1
(config-track-track1)#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the sections listed below:
cross-connect on page 67
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order:
dampening-interval on page 2978
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2979
log-changes on page 2980
shutdown on page 2981
snmp trap state-change on page 2982
test if on page 2983
test list on page 2987
test list weighted on page 2990
time-schedule <name> on page 2993
60000CRG0-35E
T C
RACK OMMAND
2938.
Copyright © 2012 ADTRAN, Inc.

Network Monitor Track Command Set

S
ET
Network
2977