ADTRAN AOS Version R10.1.0 Command Reference Manual page 3052

Command Reference Guide
hardware-address
Use the hardware-address command to specify the name of a Dynamic Host Configuration Protocol
version 4 (DHCPv4) client. Use the no form of this command to remove the configured client name.
Variations of this command include:
hardware-address <mac address>
hardware-address <mac address> <type>
hardware-address <mac address> ethernet
hardware-address <mac address> ieee802
Syntax Description
<mac address>
<type>
ethernet
ieee802
60000CRG0-35E
Specifies a valid 48-bit medium access control (MAC) address. MAC
addresses should be expressed in the following format xx:xx:xx:xx:xx:xx (for
example, 00:A0:C8:00:00:01).
Optional. Specifies one of the hardware types listed in RFC 1700. Valid
range is 1 to 21.
The valid hardware types are as follows:
1 10 Mb Ethernet
2 Experimental 3 Mb Ethernet
3 Amateur Radio AX.25
4 Proteon ProNET Token Ring
5 Chaos
6 IEEE 802 Networks
7 ARCNET
8 Hyperchannel
9 Lanstar
10 Autonet Short Address
11 LocalTalk
12 LocalNet (IBM PCNet or SYTEK LocalNet)
13 Ultra link
14 SMDS
15 Frame Relay
16 Asynchronous Transfer Mode (ATM)
17 High Level Data Link Control (HDLC)
18 Fibre Channel
19 Asynchronous Transfer Mode
20 Serial Line
21 Asynchronous Transfer Mode
Optional. Specifies standard Ethernet networks.
Optional. Specifies IEEE 802 standard networks.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3052