ADTRAN AOS Version R10.1.0 Command Reference Manual page 3245

Command Reference Guide
rtp packet-delay
Use the rtp packet-delay command to configure the maximum Realtime Transport Protocol (RTP) packet
delays. This command is used to set the allowable limits of latency on the network. Use the no form of this
command to return to the default value. Variations of this command include:
rtp packet-delay fax <value>
rtp packet-delay maximum <value>
rtp packet-delay nominal <value>
Syntax Description
fax <value>
maximum <value>
nominal <value>
Default Values
By default, the RTP packet delay for fax is 50, maximum is 100, and for nominal is 50.
Command History
Release 11.1
Release 15.1
Release A2
Usage Examples
The following example configures the RTP maximum delay time on MGCP endpoint 1 to 200 milliseconds:
(config)#voice mgcp-endpoint 1
(config-mgcp-1)#rtp packet-delay maximum 200
60000CRG0-35E
Sets the fax delay time value in increments of 10 milliseconds. Range is
0 to 500 milliseconds.
Sets the maximum delay time value in increments of 10 milliseconds.
Range is 40 to 320 milliseconds.
Sets the nominal delay time value in increments of 10 milliseconds. Range
is 10 to 240 milliseconds.
Command was introduced.
Command was added to the Voice Line Interface.
Command was added to the Media Gateway Control Protocol (MGCP)
endpoint configuration.
Copyright © 2012 ADTRAN, Inc.
MGCP Command Set
3245